C&C Exhausts, Hillington.

[Ken 275]

Does anyone (and I'm sure someone does) have directions for where to find the premises?

Finding Hillington is not hard but trying to locate the workshop could take a bit longer.

TIA.

Ken

 

[wrxmania]

Turn right at the roundabout at McDonalds and head into the estate - then a few turn down turn down a road to the right and look for a row of shutters with RED colouring.  They are beside a golf place, a windscreen/glass place and a golf shop.

Directions here:

http://www.stainlessexhausts.com

Give them a phone when you get near.

Brian []

[st3ph3n]

I think it's a Burglar King if I'm not mistaken Brian.

But other than that I do believe you're spot on.

[the squiggle]

Have you been on the drink Brian as they directions are shat to say the least

Its a bloody Burger King not a McDonalds

Of fthe M8 into Hillington

First Roundabout turn right into the estate

Next Roundabout turn right

100yds up the road turn left and then you will see the units on your right hand side.

If he has followed your directions then he would have ended up in my house

[mctwistuk]

does anyone have any experience of exhausts from this place?

 

am thinking of getting a back box from there.

 

 

[wrxmania]

Yes - they are poor directions - I was trying to be helpful in 2.1 seconds flat at lunchtime []

As to quality - yes - they are VERY good, as are Meercat in Kilbirnie.

Brian []

[~ ~ Cal ~~]

Hate to pee on the fire but they did not mandrill bend a custom mid-pipe they once made up for my old Civi Type R. Not a big issue but purists may disagree ( I did not bother too much though)

I agree they do an immense job but they will never match the likes of H&S for quality.

However, there service is top notch and they did spend a hell of a lotta time developing Alan G's exhaust......

So they still get my vote but be canny

CGS

[fai17]

Meercat don't mandrel bend pipe either as he told me the proper machine to do the job is mega expensive so he just buy in pre formed bends to do the great pipe work.

[wrxmania]

Same with C&C I assume as they are a small outfit.  I'll ask them.

Brian []

[wrxnut]

ive had work done from exhausts uk and it was a cracking job , they also have some direct fit exhausts for sale.  i have on mine and it goes and sounds great!

 

. 

[dougster]

When are you going over Ken as I know exactly where it is.

[AlanG]

Probably depends on what components they have in stock at the time, but they do have a pipe bender on the premises... can't do 4" though... or at least couldn't do 4" when i was last there.

[Ken 275]

Events have changed since this chestnut was first aired but cheers for the offer D.

[dougster]

Ahhh, I see it was bumped up from April............................