Jump to content

Wheel Alignment check in Cambs


Recommended Posts

Carnetix in Melton Mowbray will do a complete setup for you, even do a custom job based on your requirements/driving style. Not too far from you either. Then you can drive the B676 back to the A1 at Colsterworth to try it out!!  They have a website which you can google. I found them to be great and they are Subaru and Saab specialists.

Link to comment

Or you can go to Zen (I notice you got your engine from Paul) - he takes the car over to the Ford garage opposite and then does the work himself.

 

BTW,  what colour is your car? I'm in the Huntiingdon area and I see a fair number of scoobs around.

 

M

 

Link to comment
  • 2 weeks later...

Belated reply: mines a rally blue bugeye, with an STI8 scoop:

 

 sti_flaps_frq.jpg

 

 

Is yours the one I've seen a couple of times near the hospital? I think each time I've seen it I've been on foot so you won't have noticed it. I think there's two red classics in the area, one with gold decals, one without.

 

 

M

 

Link to comment

yes mine will be seen quite a lot by the hospital, it did have decals (yellow), but got fed up and felt  conspicuous, so took them off using hairdryer. I have now booked it in for a respray to replace the paint i took off my passenger side door.

I used a new place by Homebase excellent service and cheap.

Link to comment

Carnetix in Melton Mowbray will do a complete setup for you, even do a custom job based on your requirements/driving style. Not too far from you either. Then you can drive the B676 back to the A1 at Colsterworth to try it out!!  They have a website which you can google. I found them to be great and they are Subaru and Saab specialists.

Link to comment

Carnetix in Melton Mowbray will do a complete setup for you, even do a custom job based on your requirements/driving style. Not too far from you either. Then you can drive the B676 back to the A1 at Colsterworth to try it out!!  They have a website which you can google. I found them to be great and they are Subaru and Saab specialists.

 

I'll 2nd that  [Y]

Link to comment

Carnetix in Melton Mowbray will do a complete setup for you, even do a custom job based on your requirements/driving style. Not too far from you either. Then you can drive the B676 back to the A1 at Colsterworth to try it out!!  They have a website which you can google. I found them to be great and they are Subaru and Saab specialists.

 

I'll 2nd that  [Y]

 

Thats good cos I'm going there next Friday to have Prodrive springs fitted and full geometry done..... There pricing seems good so I'll let you know what there like 

Link to comment

 

 

Thats good cos I'm going there next Friday to have Prodrive springs fitted and full geometry done..... There pricing seems good so I'll let you know what there like 

 

Glenn and Becky are really good mate,you won't be disappointed.

Tell them Lee says hi (just tell them i'm the one that they had to sort my front Prodrive springs out last week !)

 

Cheers

Link to comment

 

Glenn and Becky are really good mate,you won't be disappointed.

Tell them Lee says hi (just tell them i'm the one that they had to sort my front Prodrive springs out last week !)

 

Cheers

 

Renny,

was that the dealer fit mess up they sorted on the Hawkeye? Out of interest what camber settings did you choose and how does it ride now?

Thanks

Link to comment

 

Glenn and Becky are really good mate,you won't be disappointed.

Tell them Lee says hi (just tell them i'm the one that they had to sort my front Prodrive springs out last week !)

 

Cheers

 

Renny,

was that the dealer fit mess up they sorted on the Hawkeye? Out of interest what camber settings did you choose and how does it ride now?

Thanks

 

Yes mate,the dealer put the front spring top plates on wrong,Carnetix took the springs out again and corrected it.the dealer coughed up the labour charge tough,after a phone call from myself and putting Glenn on the phone to them to explain the technical bits or what was wrong !!

 

As far as settings go i THINK i went for 1.0 neg camber - i'll have to dig out the printout and find out for sure.

I just told them it wasn't for track use and i use mainly A & B roads but also told them i didn't want to wear the tyre insides too quickly !!

 

Whatever it is it handles much better than it did,hardly any body roll and it's a lot more positive goes into bends and roundabouts.

Link to comment

Without dishing the dirt which dealer was it or where abouts were they? just to make sure[*-)]

 

Yip I was thinking the same for camber, as that was what I had the old STi set at, but that was on standard springs....... Cann't wait to get them on and get rid of the choppy ride.

 

Thanks 

Link to comment

Well went to Carnetix last Friday and you guys are right both Becky & Glen know their stuff and did a great job. Set it up exactly how I wanted and I swear they put glue on the tyres cos it just sticks and rides flat now :unsure:

All in all very professional, friendly and good pricing..........deffo worth the trip and the roads up there are :P :P

Link to comment
Well went to Carnetix last Friday and you guys are right both Becky & Glen know their stuff and did a great job. Set it up exactly how I wanted and I swear they put glue on the tyres cos it just sticks and rides flat now :icon_joker:

All in all very professional, friendly and good pricing..........deffo worth the trip and the roads up there are :gay::laughing4:

good glad about that!! wish i could afford to get mine done, will have to be new springs and setup on the Legacy first, then the Scoob.

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...