STI spoiler fitting in cental?

[andy_robertson]

as above im gettin a new STI spoiler

anyone know wher in the central area would fit one?

[MY94]

http://www.awdmotorsport.co.uk/

Not central,Perth,but thats where I would go.

[peter_macgowan]

What model of Scoob do you have.

I fitted my own on the bugeye piece of cake. I just had to remember and silicon the 4 holes where the screws went in. The spoiler fitted perfectly no drilling.

[andy_robertson]

i have an 02 bug eye

[colinj]

Fitted my own to my classic before painting then again after with silicon at the 4 bolts!

[peter_macgowan]

I have an 02. Just lift up the boot unscrew the four corners and disconnect the spoiler light. The spoiler should lift straight off.

Slot the new one on. If it has the sponge strip right round the spoiler you might get away without the silicon but I put silicon on the for screws inside and outside the boot then slotted the new spoiler on and tightened the nuts. (silicon to be on the safe side)

I think it was either a 12mm or 14mm deep socket that I used for the nuts. If you dont have a spoiler light in your new STI one you must silicon a cap or something in the hole cable went through or you will end up with a couple of inches of water in your boot, like i did

You might need a hand just hold the spoiler in position while you are tightening the bolts.

It is pretty simple to do.

Hope this helps

[andy_robertson]

sounds str8 forward enuff!!

whats the best silicon to use?

[spooks]

If your still not sold on fitting it yourself, give Jamie ( hi soob ) a shout and see if he could help

Spooks