Jump to content

giz1978

Forum-Member
  • Posts

    28
  • Joined

  • Last visited

Everything posted by giz1978

  1. hi, i maybe a bit late but this kid will build to spec and is spot on. 07917204738 he build impreza rally car and is based in fleetwood
  2. if it was your turbo seals it will blow blue smoke out of the exhaust. sounds like the rear two half moon on the back of the rocker cover need re sealing.
  3. anyone can fit it.it is a screw out/in and plug in.
  4. if your closer i could of given you a job maybe
  5. it is a little valve which controls your idle below 1200 rpm and sets the amount of air needed to start and control your idle i.e if your car is warm it will be 75% ish out but if it cold it will wind in upto 75% ish. This is controled by the ecu off your water, air sensors,map and maf sensors. if it is sticking it will not be able to adjust right so consently trying to compensate so giving you a un even idle and poor start from cold but clears when the rev are taken above 1200rpm hope this helps a bit o cranks sensor just break down sometimes you can tapp them and it works for a bit then breaks again as it a magnet and wire wrapped around it.
  6. hi, poor start then rough running doesn't sound like crank to me, like sticking stepper.get it pluged in
  7. check your vac piping and get the ecu read sounds like maf sensor
  8. it takes about 30mins to fit
  9. hi, go to a car park, put car on ful and drive forward/backwards on both locks. If the sound changes note or becomes worse then poss diff u/s and buy a temp surface temp tester and take car for a run.test the surface were the bearing fits if it is a bearing then one will be warm and the or would be cooking
  10. hi to all well i needed to moan. i have just brought a scooby with a headgasket blown. I have start the repairs but found out it has been re built by a monkey which needs shooting so why do people think they know what they are doing just because they have bought a cd off ebay???????? i have just spent an hour grinding off all the rounded 10mm bolt which hold the cams in place. god give me strengh please plus as anyone got some off this 10mm spare please
  11. i have sen the alarm cause this problem but what it is, soz i can not help
  12. mint thread and very helpful
  13. hi, they not bad to fit and i have never seen any destruction for this kit
×
×
  • Create New...