does anyone hav a diagram of where to put oil temp sender adapter on cylinder three ?? and water temp sender too...

[rabskyline]

as above. got three gauges for pillar mount and have senders...gaugeplace sell the adapters but not 100% sure where to mount them !

[tosh 32]

you got to strip off the inter cooler to get to it

i just ordered a oil filter sandwich plate as the oil temp and pressure senders fit right into it alot better to install

with no strippin down 

[st3ph3n]

Getting the temp from above cylinder 3 gives you a higher temp reading as that's where the engine is warmest. I asked around for some advice and was told that was the best place to put it. I can't find the instructions I had for it, but I think there was a guide over on NASIOC. IC off, find the oil gallery, install the oil gallery plug, screw the sensor into that. Certainly the way it works on a new age.
 

[rabskyline]

cheers...i will endeavour to find some pics as to where it screws into ! the water temp should be on top hose if i am informed correctly !