fraser_allan Posted February 3, 2009 Posted February 3, 2009 Hi, can any one help, got my rear calipers reconed and they have been sent back with the slides taken out, as they are not the same i dont know which one goes where!!! One is soild and one has a rubber bit on the end. HELP And i take it they are to be greased before going back in. THanks an advance Fraz.
paul555sti Posted February 3, 2009 Posted February 3, 2009 Can you not get a look at Pauls to see the set up?
fraser_allan Posted February 3, 2009 Author Posted February 3, 2009 Would have to remove the caliper and dismantle it to see, dont think hed be up for that. in the name of science maybe !!!!
paulc555 Posted February 3, 2009 Posted February 3, 2009 had a think about it...and reckon you should cut the red wire....just look out for the secondary tilt switch...... see who says I know nothing about cars.......can change your front pads if you want mate....!!! not had much experience with rubber either...............I'm more of a latex man.....
StrikE Posted February 3, 2009 Posted February 3, 2009 Take a picture of the bits m8 & post it up so we can see
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now