Slide Pins

[patsy]

Has anyone bought a new set of these for the front 4 pots before? Where from and cost? Mine are very rusty, look beyond a clean up this time.

Cheers

[dipsy]

http://www.grahamgoode.com/subaru/parts.ph...amp;item=GGS155 .Is this what your looking for Edited July 12, 2009 by Dipsy

[patsy]

http://www.grahamgoode.com/subaru/parts.ph...amp;item=GGS155 .Is this what your looking for

Yeah thats the ones, for holding the pads. £6.66 each!!!! Maybe a 4" nail with a hole drilled in the end would work. lol. Stainless efforts would be good from somewhere, no rust to contend with. I might try a few factors tomorrow, like Dingbro etc.

Thanks

[notsosmall]

Yeah thats the ones, for holding the pads. £6.66 each!!!! Maybe a 4" nail with a hole drilled in the end would work. lol. Stainless efforts would be good from somewhere, no rust to contend with. I might try a few factors tomorrow, like Dingbro etc.

Thanks

There not cheap

Let us know how you get on at the motor factors ect, I could do with renewing mine after having trouble getting them out and bending the ends last time

[patsy]

There not cheap

Let us know how you get on at the motor factors ect, I could do with renewing mine after having trouble getting them out and bending the ends last time

Will do. Within the next couple of days..... Should be able to beat that price!

[corsa]

Yeah thats the ones, for holding the pads. £6.66 each!!!! Maybe a 4" nail with a hole drilled in the end would work. lol. Stainless efforts would be good from somewhere, no rust to contend with. I might try a few factors tomorrow, like Dingbro etc.

Thanks

Believe it or not thats what i did on the Corsa Rally car front willwood 4 pots, a 3" nail with a hole bored in the end with a couple of R clips to be safe.

Worked for the past three years no problem.

Davie

[kennyuk300]

Will do. Within the next couple of days..... Should be able to beat that price!

Hi mate got a full pin kit from ebay, seller was biggred think it was about £26/ 27

cheers kenny

Edited July 12, 2009 by kennyuk300

[simon_gibson]

I had got mine from AWD in perth dont know how much but dont think they where expensive give Andy a call at AWD hell sort it out.